Fitting The Remote Panel - Zanotti SP O Notice De Mode D'emploi Et D'entretien

A) open fan cover A by unscrewing the 2 screws B; drill the holes in the ceiling keeping the necessary distance
from the wall.
Secure the evaporator with the material supplied.
Electrical connection of evaporator: connect the evaporator using the wires supplied; pay attention to wire and
terminal board numbers. Close the connection box and fix the cable so that it does not interfere with fan
operation.
Close evaporator cover by repeating operations A) in reverse order.
Connection of refrigerating system: carefully straighten the pre-charged tubes supplied and connect them to the
condensing and evaporating units.
ATTENTION
Use a suitable tool ensuring correct tightening.
Fit a drain line to the condensate water drain connection in the lower part of the evaporator.

6.6 Fitting the remote panel :

Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in a vertical position.
Mod. D
SPO121 508
SPO221 928
SPO135 1508
21