Fitting The Remote Panel - Zanotti GS Série Notice De Mode D'emploi Et D'entretien

Electrical connection of evaporator: connect the evaporator using the wires supplied; pay attention to wire and
terminal board numbers. Close the connection box and fix the cable so that it does not interfere with fan
operation.
Close evaporator cover by repeating operations A) in reverse order.
Connection of refrigerating system: carefully straighten the pre-charged tubes supplied and connect them to the
condensing and evaporating units.
ATTENTION
Use a suitable tool ensuring correct tightening.
Fit a drain line to the condensate water drain connection in the lower part of the evaporator.

6.6 Fitting the remote panel:

ATTENTION
Maximum distance between panel and unit is 10 mt. For longer distances the special
"long distance module" should be used.
ATTENTION
Check that the unit and its devices have suffered no damages during transport. Pay
special attention to the components secured to the electric panel door and to the
refrigerating circuit pipes. Mount the unit as shown in the drawings; make sure that the
electric connections are carried out properly.
Fix the back plate to the wall using the pre-drilled holes; be careful the panel is kept in
a vertical position.
Fit the connecting cable between panel and unit making sure not to bundle it with other
cables.
23