Installation; Plates; Dimensions; Location - Zanotti SP O Notice De Mode D'emploi Et D'entretien

6 Installation

6.1 Plates

The unit is supplied with warning and attention plates as listed in the relevant table.

6.2 Dimensions

6.3 Location

Solution 1
Solution 2

6.4 Free room

When installing the unit leave enough free room to allow opening, correct use and easy
maintenance in safe conditions.
6.5 Installation
Place the condensing unit on the floor.
Install the evaporator as follows:
A
SPO 121-123 357
SPO 221 390
SPO 135 427
To obtain optimal operation of the unit act as follows:
A) Place the unit in a well ventilated room, far from heat sources.
B) Limit the number of door openings.
C) Make sure that the unit has good air supply and discharge.
D) Fit a drain line to the defrost water drain connection in the lower part of the
evaporator.
B C
337 620
427 820
427 820
Solution 3
D
614
1034
1614
Installation in a
coldroom with
more than one unit
20