Operation - Abus FUBE50060 Instructions D'installation

9. Operation

Arming
To activate your Secvest wireless alarm centre, turn the key to the right as
far as possible. The cam activates the left button (11).
A short flashing of the right, red LED (14) shows you that the wireless key
switch has sent the information to the system and that the battery has
sufficient capacity. If the LED does not light up (during battery operation),
check the state of the battery.
Following expiry of the exit delay, the wireless alarm system is activated
and sends the information that it is armed to the wireless key switch. The
wireless key switch signals this by lighting up the right, red LED (14) for ca.
6s. The wireless key switch beeps twice.
Disarming
To deactivate your Secvest wireless alarm centre, turn the key to the left as
far as possible. The cam activates the right button (12).
A short flashing of the left, green LED (13) shows you that the wireless key
switch has sent the information to the system and that the battery has
sufficient capacity. If the LED does not light up (during battery operation),
check the state of the battery. Following disarming, the Secvest wireless
alarm system sends the information that it is disarmed to the wireless key
switch. The wireless key switch signals this by lighting up the left, green
LED (13) for ca. 6s. The wireless key switch beeps once.
Note:
The wireless key switch beeps eight time when it cannot receive any status
information from the wireless alarm centre.
37