Abus FUBE50060 Instructions D'installation page 22

0. Preface
Dear Customer,
Thank you for purchasing this surface-fitted wireless key switch for your
Secvest wireless alarm system. This product was designed and built using
state-of-the-art technology, which complies with the current standards of
domestic and European regulations. "ABUS Security-Center GmbH & Co.
KG, hereby declares that the device with item number FUBE50012
complies with the essential requirements and other relevant provisions of
Directive (1999/5/EG). The declaration of conformity can be obtained from
the following address: ABUS Security-Center GmbH & Co. KG, Linker
Kreuthweg 5, 86444 Affing, GERMANY"
To maintain this status and to guarantee safe operation, it is your
obligation to observe these instructions.
They contain important installation and operation information. Store these
instructions in a safe place for future reference. These instructions are an
important product accessory. Bear this in mind if you pass the product on to
others.
Everything possible has been done to ensure that the contents of these
instructions are correct. However, neither the author nor ABUS Security-
Center GmbH & Co. KG can be held liable for loss or damages caused
directly or indirectly by these instructions, whether real or alleged. We
reserve the right to make changes to these instructions without prior notice.
© ABUS Security-Center GmbH & Co. KG, 03 / 2014
1. Usage in accordance with regulations
This wireless key switch is used for the simple activation and deactivation
of your Secvest wireless alarm system.
Furthermore, an output of your Secvest wireless alarm system can be
controlled using the wireless key switch. You can use it, for example, to
open and close garage doors or window blinds.
This key switch is assigned to a specified user of your Secvest by a
programmed user code. The authority of this user determines which
partition can be switched.
Main areas of use are entrance doors, garage doors, and access areas of
all types.
22