Steplesstouchcontrol (Slt-Control); Initial Operation; Cleaning - Graef Stabmixer HB 802 Instructions D'utilisation

• When fully charged, the unit can be operated for about 20 minutes, depend-
ing on the relevant use.

SteplessTouchControl (SLT-Control)

The unit is equipped with a variable speed control. You can determine the speed
by pressing a finger on the speed switch.
Slight pressure on the switch - minimum speed
Firm pressure on the switch - maximum speed

INITIAL OPERATION

Foodstuffs must not be processed when they are too hot, because hot liquids
might spurt out of the container due to suddenly occurring steam clouds. Hot
foodstuffs can lead to burns.
When you have assembled the hand-held blender set as desired, proceed as
follows:
1. Hold the immersion blender / whisk / cleaning brush into the desired food-
stuff/container.
2. Press the speed switch completely to the highest speed step and keep press-
ing it for 3 seconds in order to release the unit.
3. Press the speed switch again until the desired speed step is reached. You
select the speed by means of your intuitive pressure on the speed switch.
4. After finishing the process, release the speed switch. Wait until the motor
has come to a standstill before removing the immersion blender / whisk /
cleaning brush from the mixed food.

CLEANING

Pull the mains plug before each cleaning process.
1. Disconnect the motor unit from the respective adapter by pressing the side
buttons.
2. Clean the motor unit using a damp cloth.
36
Clean all components immediately after operation.