Http-Api - Parrot SEQUOIA Guide Utilisateur

Event
Properties
Refer to the documentation for your PTP or PTP/IP software (gphoto2
or ptpcam for example).
For more information on the Sequoia PTP and PTP/IP protocols, see the
Integration Guide available in the Sequoia set up interface help section
and on www.parrot.com/uk/support.
You can control Sequoia via HTTP. All data is exchanged in JSON
format.
The main URLs are:
/capture
/config
/status
/calibration
/storage
32
STATUS
MAGNETO_CALIBRATION_STATUS
PHOTO_SENSORS_ENABLE_MASK
PHOTO_SENSORS_KEEP_ON
MULTISPECTRAL_IMAGE_SIZE
MAIN_BIT_DEPTH
MULTISPECTRAL_BIT_DEPTH
HEATING_ENABLE
WIFI_STATUS
WIFI_SSID

HTTP-API

See the Sequoia's snapshot status.
Start/stop a snapshot.
See the camera settings and configure them.
Get information on the physical state of
Sequoia.
Get the calibration status and start/stop
calibration.
Get information on the Sequoia's memory.