Configuring Sequoia - Parrot SEQUOIA Guide Utilisateur

You can set up Sequoia using either flight planning software (such as
Pix4Dmapper Capture or eMotion from SenseFly for example), or Wi-Fi
via an HTML interface. Your set up data will be saved in the Sequoia
memory.
Setting up Sequoia via Wi-Fi
Wi-Fi is enabled on Sequoia as the default option. Press four times on
the multispectral sensor button to enable/disable Wi-Fi on Sequoia.
Subsequently, Sequoia keeps the last Wi-Fi set up in its memory, when
it is switched on or off.
You can set up Sequoia from a computer, smartphone or tablet:
1. Connect the multispectral sensor USB device port to a drone or a
USB battery.
> Sequoia turns on automatically.
2. Make sure that the Wi-Fi appears in the list of available Wi-Fi. If not,
press four times on the multispectral sensor button.
3. Connect to the Wi-Fi network: Sequoia_XXXX.
4. Open your internet browser
5. Type the following address in your browser's address bar:
192.168.47.1
> The HTML interface for setting up Sequoia opens. You can set
up Sequoia.
HTML interface for setting up Sequoia
The Sequoia set up interface consists of three screens:
• Home
• Status
• Gallery

CONFIGURING SEQUOIA

13