Checks To Be Made Before Use - Parrot SEQUOIA Guide Utilisateur

You can view photos in the Sequoia's internal memory or on the SD
card.
Gallery tells you how much space is available in the Sequoia's internal
memory and on the SD card.
Settings
• Edit the Sequoia's Wi-Fi name, and enable/disable the Wi-Fi.
• Use the "Force calibration" button to recalibrate Sequoia.
• Use the "Update Sequoia" button to update Sequoia.
• Use the "Restore to factory settings" button to restore the Sequoia
to factory settings.

CHECKS TO BE MADE BEFORE USE

Before each flight with Sequoia, make the following checks:
• Make sure that the lenses are clean. Use the microfibre cloth (sup-
plied) to clean them.
• Free up enough memory (either in the multispectral sensor internal
memory, or on your SD card) so you can save all the photos taken
during the flight.
• Make sure that the two modules are properly attached to the drone
and that they are not likely to come off during the flight.
• Make sure that the micro USB device cable which connects the
drone to the multispectral sensor is connected.
• Make sure that the two sensors are calibrated. For more informa-
tion, see the Calibrating Sequoia section.
• Wait until the sunshine sensor indicator light is green. When it is
green this means that the GPS/GNSS is enabled.
17