Publicité
Les langues disponibles
Les langues disponibles
Titanium
Operation of the Titanium
Charging the batteries
• Before using the divice, fully charge th
batteries
• Open the battery compartment (E), insert
the batteries and connect the plugs to
the sockets. The plugs fit in the sockets in
one position only (see pictures on right).
Reclose the battery compartment.
• Connect the battery charger/mains unit
to a mains source and plug into the
socket (S). Please only use the
charger/mains unit supplied with the
device. If a different one is used, the war-
ranty will become void.
• The device can also be operated with standard alkali batteries (4 x type D).
Insert the batteries as shown by the installation symbols. Ensure the polarity
is correct.
• If the LED (T) blinks constantly, either the batteries must be exchanged or
recharged.
Insertion of batteries in the SensoLite and SensoCommander:
• Remove the battery cover (9) and insert the batteries as shown by the
installation symbol, ensuring that the polarity is correct. Then replace the
cover.
• To extend battery life, the receiver switches off automatically after about 5
minutes if not used. You could switch off the SensoCommander with the
buttons 16 or 17.
Note:
Do not expose batteries to excessive heat such as sunshine, fire, etc. Dry batteries
must not be recharged. Used batteries must not be disposed of as household
waste. Please take them to a collection point for used batteries or for special
waste. Ask your local authority for further details. Batteries with the recycling
symbol can also be returned to our dealerships or to our Technical Service.
20
Deutsch
ENGLISH
1
Publicité
