Alarm Setting; Display Brightness Control; Battery Disposal - UNITEC Climate W185 Manuel De L'utilisateur

ALARM SETTING

Press [ALARM] 3 to show alarm time and "AL." (A)
icon will appear. Press repeatedly to enable or disable
the alarm. Bell icon " " (A) appears when alarm is
enabled.
Hold [ALARM] 3 to enter alarm time setting mode.
Press [s] 4 or [t] 5 to enter the desired Hr/ Min
values and press [ALARM] 3 to confirm setting.
SNOOZE
When alarm is going off, press [CHANNEL/SNOOZE]
1 to trigger snooze alarm and " " (A) icon will flash.
To stop alarm for one day, press [ALARM] 3 key.

DISPLAY BRIGHTNESS CONTROL

Select display brightness mode with the slide switch
9 on the back casing.
AUTO:
Display brightness is adjusted automatically accor-
ding to the surrounding brightness detected by the
light sensor  located on the upper back casing. In a
bright environment, display brightness will increase.
As the environment turns dark, display brightness
will reduce.
TECHNICAL DATA
Power supply of main unit:
Battery type of main unit:
Temperature range of main unit:
Temperature tolerance of main unit:
Humidity range of main unit:
Humidity tolerance of main unit:
Operating temperature:
Temperature display resolution:
Humidity resolution:
Power supply of remote sensor:
Battery type of remote sensor:
Temp. Range of remote sensor (W186-L):
Temperature tolerance of remote sensor:
Humidity range of remote sensor (W186-L):
Humidity tolerance of remote sensor:
Transmission frequency:
Max. range (under opt. conditions):
Number of remote sensors:
English
313507.00_W185_Manual_160329.indd 10
Note: Auto mode is recommended for power
saving, display lifetime and convenient purpose.
Important: Avoid having obstacle above the light
sensor window for an accurate light sensing result.
Otherwise the display will turn dim even in bright
environment.
• High:
Turn to high brightness mode
• Low:
Turn to low brightness mode
• Off: Turn off display backlight

BATTERY DISPOSAL

Replace only with the same or equivalent type re-
commended by the manufacturer. Please disposal of
old, defective batteries in an environmentally friendly
manner in accordance with the relevant legislation.
DISPOSAL OF WASTE ELECTRICAL AND
ELECTRONIC EQUIPMENT (WEEE):
Do not dispose of this product in your household
waste; hand in at a collection point for Waste Elec-
trical and Electronic Equipment. The symbol on the
product, in the instruction leaflet or on the packaging
indicates the correct manner of disposal.
7.5 V power supply
2 x LR 44
0 ºC to +50ºC
+/-1 ºC
20% to 99% RH
+/-5%
0 ºC – 50 ºC
0.1 ºC
1%
2 x 1.5V
2 x AAA / LR03 / AM4
–20 ºC to +60ºC
+/-1 ºC
20% bis 99% RH
+/-5%
433 MHz
30m
3
10
29.03.16 15:03