Beurer medical BM 35 Mode D'emploi page 18

Select memory
Switch on the blood pressure monitor with the
Select the required memory space by pressing the function key
+. You have two memories (60 memory spaces each) in order
to save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the
position in which you want to carry out the measurement.
• Using the buttons +, select the user memory 1 or 2. Start the
measurement process by pressing ON/OFF button
checking the display with all digits lighting up, the monitor
will automatically inflate. Following the self-test, during which
all display elements briefly appear, the measurement begins.
During inflation the device already determines measured val-
ues used to estimate the required inflation pressure. If this
pressure is insufficient, the device automatically inflates by
another.
• Then the pressure in the cuff is slowly released and the pulse
is measured.
• When the measurement has been completed, the remaining
air pressure is released very quickly. The pulse, the systolic
and the diastolic blood pressure are displayed.
• You can interrupt measurement at any time by pressing the
ON/OFF button .
• The _ icon appears if it has not been possible to perform
the measurement properly. Observe the section in these
instructions on error messages/troubleshooting and repeat
the measurement.
• The device switches off automatically after 1 minute.
Wait at least 5 minutes before taking another measurement!
button.
Evaluating results
Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia disor-
ders during measurement and if necessary indicates the meas-
urement with the flashing icon
This may be an indicator for arrhythmia. Arrhythmia is a condi-
tion where the heart rhythm is abnormal as a result of defects
in the bioelectrical system controlling the heart beat. The
symptoms (omitted or premature heart beats, slow or exces-
. After sively fast heart rate) may be caused, among other things,
by heart disease, age, physical predisposition, excessive use
of stimulants, stress or lack of sleep. Arrhythmia can only be
ascertained through examination by your doctor.
Repeat the measurement if the flashing icon
after the measurement. Please note that you should rest for 5
minutes between measurements and not talk or move during
the measurement. If the icon
tact your doctor. Any self-diagnosis and treatment based on
the test results may be dangerous. It is vital to follow your doc-
tor's instructions.
Risk indicator:
The measurements can be classified and evaluated in accord-
ance with the following table.
The bar graph in the display and the scale on the unit indicate
the range of the blood pressure which has been recorded. If
the values for systolic and diastolic pressure are in two differ-
ent ranges (e.g. systolic in the high-normal range and diastolic
pressure in the normal range) the graphic classification on the
18
.
is displayed
appears often, please con-