Sony VPL-DX10 Guide De Référence Rapide page 36

5
Insert the new lamp all the way in until it
is securely in place (a). Tighten the two
screws (b). Fold down the handle to
replace it (c).
Notes
• Be careful not to touch the glass surface
of the lamp and a inside conductor.
• Insert the handle firmly to attach it
securely.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten the
screw.
Note
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Turn the projector back over.
8
Connect the power cord.
The ?/1 key lights in red.
16
GB
Replacing the Lamp
9
Press the ?/1 key to turn the projector
on.
10
Press the MENU key, and then select the
Setup menu.
11
Select "Lamp Timer Reset", and then
press the ENTER key.
Fold down
the handle.
"Settings for Lamp replacement. Has the
projection Lamp been replaced?" is
displayed in the menu screen.
12
Select "Yes" with the b key, and then
press the ENTER key.
The Lamp Timer is initialized to 0,
"Lamp Timer Reset Complete!" is
displayed in the menu screen.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains
mercury. Disposal of these materials
may be regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the
Telecommunications Industry
Association (www.eiae.org).
Lamp Timer Reset
Settings for Lamp replacement.
Has the projection Lamp been replaced?
Yes No