AEG MC 4407 CD/MP3 Mode D'emploi & Garantie page 39

• Insert the plug into a properly installed 230 V, 50 Hz power
socket. Please ensure that the mains voltage corresponds to
the information on the type plate.
Setting the Time (in Standby Mode)
1. Keep the TIME SET button (10) pressed down.
2. Press the STOP button (17) in order to set the hours. Keep
the button pressed down until the desired hour is reached.
3. Press the PLAY/ PAUSE (14) button in order to set the
minutes. Keep the button pressed down until the desired
minutes are reached.
4. The time is stored automatically.
Note: The lithium cell in the battery compartment of the remote
control has been secured for transport with a foil. This prolongs
the lifetime of the battery. Before initial use please remove this
foil so that the remote control is ready for operation.
Inserting the Batteries
The battery of the remote control is a long-life lithium cell. If
the range of the remote control is reduced during use, please
proceed as follows:
• Open the battery compartment on the back of the remote
control.
• Replace the cell by a battery of the same type. Ensure
correct polarity.
• Then close the battery lid.
If the remote control is not used for a prolonged period, remove
the batteries in order to prevent battery acid leaking.
Warning: batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the relevant
collection bin or at your dealer's.
Never throw batteries into the fi re.
CD deck transport protection
• Please open the CD compartment (11) by pressing the
OPEN button (12).
• Remove the transport protection from the CD player if
present before use.
General Operation
Mains Button (4)
Switch the device to the standby mode with the „ " button (the
time is displayed). If this button is pressed once more, the device
switches on again.
Volume
You can set the desired volume using the VOL+/VOL- control (5).
05-MC 4407 CD AEG 39
Headphone Socket (1)
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the socket. The loudspeakers are
then switched off.
Infrared remote control
For operating the music centre from a distance of up to 5 metres
without a lead. If the range of the remote control is reduced, the
batteries have to be replaced. During operation ensure that there
is nothing blocking the direct line between the remote control
and the sensor (3) on the machine.
AUX IN socket (9)
To connect analogue replay devices. Use this jack to replay
sound of other replay equipment such as DVD players, compu-
ters, etc. via the loudspeakers.
1. Open the (20) fl ap.
2. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX IN socket.
3. Turn the function selector switch (6) to the AUX position.
4. Through the loudspeakers you will hear the sound played
back from the external device; you can change the volume
with the VOL+/VOL buttons (5). The CD buttons have no
function in this mode.
5. For the remaining procedure please see the operating
instructions of the external sound source.
USB Connexion (7)
This device has been developed in accordance with the latest
technical developments in the USB fi eld. Unfortunately the large
number of different types of USB storage media on offer today
makes it impossible to guarantee full compatibility with all USB
storage media.
1. In order to switch on the device please press
the switch (4).
2. Open the (20) fl ap.
3. Turn the function selector switch (6) to the CD position.
4. Connect a USB storage medium.
5. Hold the PLAY/PAUSE (14/1) button down for approx.
3 seconds until the letters USB appear in the display. The
device is now in USB mode. After a few seconds the total
number of songs/tracks is shown in the display (13).
6. The music fi les are played back from the fi rst track on.
The track currently being played,
display (13).
7. For operating instructions please see the section "Playing
CDs/MP3s".
8. If the USB connection is no longer needed, hold the PLAY/
PAUSE (14/1) button down for approximately 3 seconds until
the letters USB disappear from the display. The device is
now in CD mode.
Important: Before you remove the USB storage medium turn
the function selector switch (6) to the FM position.
Note: If you have problems with operation using the USB conne-
xion, please use an appropriate adapter cable and proceed as
described under AUX IN.
MP3 are shown in the
39
24.03.2006, 10:02:51 Uhr