Adjusting The Legs; Installation (Under The Counter) - Beko B1753HCN Manuel D'utilisation

Adjusting the legs

If your refrigerator is unbalanced;
You can balance your refrigerator
by turning its front legs as illustrated
in the figure. The corner where the
leg exists is lowered when you turn
in the direction of black arrow and
raised when you turn in the opposite
direction. Taking help from someone to
slightly lift the refrigerator will facilitate
this process.
Installation (Under the
counter)
Internal height of the counter should
be 820mm.
(!) Cookers or other heat sources
must not be placed above the
counter where the appliance is
installed under the counter.
The mains wall socket plug must be
close to the right or left hand side of
the appliance.
appliance. There are 4 screws(2
pieces at the back, 2 pieces below
the front edge) that should be
removed. Fig. 1
Cut the part shown in the picture and
then remove it by the help of pliers.
Place you appliance under the
counter and adjust the front feets until
its top touches to the counter.
In order to use the product under the
counter, the distance between the
wall and the reference indicated in
the top connection plastic must be
minimum 595 mm.
Fig. 2-3
Fix the appliance under the counter
by using 2 of the screws that was
removed from the top cover.(Material
of the counter must be plastics or
wood based!)
Fig. 4
11
EN