Check-Out - Quickie Pulse 6BC Mode D'emploi

Q UI C KIE PU LS E
2. Moving the controller from one side to the other
a. Turn off the power to the controller.
b. Unplug the controller connectors from the power base.
c. Remove any wire ties securing the controller harness to the
armrest.
d. Flip up the armrest so that it is perpendicular to the floor as
shown(Figure 44)
e. Loosen the thumbscrew (B) on the controller bracket and
slide the controller out.
f. Re-tighten the thumbscrew (B), so it won't be lost acciden-
tally.
g. Loosen the thumbscrew on the other armrest.
h Slide the controller arm into the other armrest, and tighten
the thumbscrew.
I. Route and secure the controller harness to the back of the
power base and plug in the controller cord. Make sure to
avoid any areas where the cord may be pinched.
W. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll
smoothly and easily. All accessories should the checked to make
sure they are also performing smoothly. After the wheelchair has
been set-up, be sure that the chair performs to ytour specified
operational settings.
If the chair does not perform the way you expecte it to, (accord-
ing to specifications), turn your wheelchair OFF immediately and
contact your authorized supplier to re-program operational set-
tings using the RNET operating guide.
If you have any problems, follow this Procedure:
a. Review the Set-up, Adjustment, and use section and the
Operating Guide to make sure the chair was properly pre-
pared.
b. If your problem persists, contact your authorized supplier. If
you still have a problem after contacting your authorized
supplier, contact Sunrise Medical Customer service. See the
introduction page for details of how to contact the people
who can help you.
119832Rev. D
VIII. SET-UP, ADJUSTMENT, AND USE
24