Set-Up, Adjustment And Use; Adjustment Notes; C.battery Removal - Quickie Pulse 6BC Mode D'emploi

Q UI C KIE PU LS E
A. ADJUSTMENT NOTES
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your
chair. This makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-
strength fasteners and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert
to help prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage
to chair parts.
3. If bolts or screws become loose, tighten them as soon as
you can. Loose bolts or screws can cause damage to other
chair parts causing them to fail.
4. Washers & Spacers:
• Note the position of washers and spacers before disassem-
bly.
• To avoid damage to the frame, replace all washers and spac-
ers when you reassemble parts.
5. Torque Settings:
• A torque setting is the optimal tightening for a particular fas-
tener. Use a torque wrench that measures inch-pounds to
secure screws, nuts and bolts on this chair.
NOTE– Unless otherwise noted, use a torque setting of 120 in-lbs
for all fasteners.
B. TOOLS YOU MIGHT NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you may need the
following tools:
• Combined Phillips and flat screw driver
• Standard metric wrenches from 10mm - 19mm
• Metric Hex wrenches from 5mm - 8mm
• Metric socket set 10mm - 19mm
• Imperial Allen wrenches from 5/64" to 1/4"
• Wire cutters, and Needle nose plyers
• Torque wrench that can measure up to 120in-lbs
You can obtain a multi-purpose tool kit from Sunrise, or buy the
tools you need from a hardware store.
119832Rev. D
WARNING
VIII. SET-UP, ADJUSTMENT AND USE
C. BATTERY REMOVAL
1. To remove the batteries before transporting or servicing:
a. Carefully remove seat (see Section O Seat removal)
b. Remove the shroud by first removing the six fasteners
(Figure 10), then lift up and remove the shroud.
c. Unplug the main power connect (A) (figure 11)
d. Lift the batteries out of the frame using the battery strap as
a lifting handle.
2. Battery installation
• See section X. (Batteries) for installation
Batteries may weigh up to 39 lbs. Care must be taken to avoid
injury when lifting up on battery straps.
A
16
10 11
WARNING
10
11