Cleaning The Appliance - Siemens KI-N Série Notice D'utilisation

Cleaning the appliance

Attention!
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
Do not use scouring or abrasive sponges.
The metallic surfaces in the appliance
could corrode.
Never clean shelves and containers in
the dishwasher. The parts may warp!
Proceed as follows:
S Before cleaning: Switch off the
appliance.
S Pull out the mains plug or switch off
the fuse.
S Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing up liquid. The rinsing water
must not run into the light.
S Wipe the door seal with clear water only
and then wipe dry thoroughly.
S Rinsing water must not run through the
drainage hole into the evaporation area.
S After cleaning reconnect and switch on
the appliance.
Note
Regularly clean condensation channels
and drainage hole, Fig. 9, with cotton
buds, etc. so that the condensation can
run out. The upper condensation channel
can be taken out for cleaning.
After cleaning the appliance, re insert the
stopper into the drainage hole for
functional reasons.
Cleaning the equipment
To clean the equipment, all variable parts
of the refrigerator compartment can be
taken out (see chapter Variable interior
design").
Taking out the drawers
Fig. 0
Tilt drawers forwards and take out.
To insert drawers, place the front of the
drawer on the telescopic rails and push
into the appliance. The drawer is engaged
by pushing it into the appliance.
Taking out the telescopic rails
Fig. w
1. Pull out the telescopic rails.
2. Push lock in the direction of the arrow.
3. Detach telescopic rail from the rear pin.
4. Push telescopic rail together, push
backwards above the rear pin and
disengage.
Install telescopic rails.
1. Place the extended telescopic rail on
the front pin.
2. Pull the telescopic rail forwards slightly
until it engages.
3. Place telescopic rail on the rear pin.
4. Push lock backwards
Take glass shelves out of the freezer
compartment
Lift shelf at the front and take out.
en
35