Korg SV-1 Stage Vintage Piano Mode D'emploi page 38

24 – Using the SV-1 | Selecting and editing the effects
NOTE: Extreme DRIVE settings may cause unwanted distortion. If this happens, lower its set-
ting.
AMP MODEL type
Amp1 (Clean Combo)
Amp2 (California)
Amp3 (Tweed)
Amp4 (AC30)
Amp5 (Modded OD)
Organ Amp (Korg OD/HG)
Use the TYPE knob of the MODULATION FX section to select a different modu-
5.
lating effect (chorus, phaser, flanger or rotary speaker). If the rotary effect is
selected, use the SLOW/FAST button to change the rotor's speed.
You can change the speed of the modulation (or horn rotation) by using the SPEED
knob, and the intensity (or horn acceleration) by using the INTENSITY knob. To
return to the default settings, press the SPEED or INTENSITY knob.
HINT: If you select the rotary effect, and a footswitch pedal is connected to the PEDAL 1 jack
on the back of the instrument, you can use the pedal to switch the rotor speed between the
SLOW and FAST settings.
MODULATION FX type
Chorus 1
Chorus 2
Phaser 1
Phaser 2
Flanger
Rotary
Use the TYPE knob of the REVERB/DELAY section to select a different reverb,
6.
echo or delay effect.
If the stereo delay effect is selected, input its time by "tapping" it four times on the TAP
button. The LED flashes at tempo, so that you can understand visually if the tempo is
right. If the tempo was not entered correctly, the LED does not flash.
You can change the intensity of the effect by using the DEPTH knob. To return to
the default setting, press the DEPTH knob.
REVERB/DELAY type
Room
Plate
Hall
Spring
Tape Echo
St. Delay
SPEED knob
Speed
Speed
Speed
Speed
Speed
Horn Speed
DRIVE knob
PreVol
PreVol
PreVol
PreVol
PreVol
Drive
INTENSITY knob
Depth
Intensity
Depth
Color (type 1, 2)
Depth
Horn Accel
DEPTH knob
Mix
Mix
Mix
Mix
Mix
Mix