Set Up The Product; Connect The Power Supply - HP SCANJET ENTERPRISE 7000n Guide De Démarrage Rapide

Back of product
1. Power switch
2. Power connector
3. USB ports

Set up the product

Complete the following tasks in order to set up the scanner hardware and prepare it for use.

Connect the power supply

The green LED on the power supply case is on when the power supply is functioning correctly.
1. Connect the power supply to the power supply cable, and then plug the power supply cable into
a power outlet or a surge protector.
2. Check that the green LED on the power supply case is on.
● If the green LED is not on, ensure that power is available to the power outlet or surge
protector that the power supply cable is plugged into.
●
If power is available to the power outlet or surge protector but the green LED is still not on,
the power supply might be defective. Contact HP Support for assistance.
1 2 3 4 5 6
4. Network link speed indicators
5. Ethernet port
6. Covered Ethernet port for service access
Starting up 3