Table des Matières
Publicité
(in standby mode)
Important notes for users in
the U.K.
Mains fuse
This information applies only to products with a
UK mains plug.
This product is fitted with an approved non-
molded plug. If you replace the fuse, use one
with:
‡
the ratings shown on the plug,
‡
a BS 1362 approval, and
‡
the ASTA approval mark.
Contact your dealer if you are not sure
about what type of fuse to use.
Caution: To confor m with the EMC
directive (2004/108/EC), do not detach the
plug from the power cord.
(in standby mode)
How to connect a plug
The wires in the power cord are colored as
follows: blue = neutral (N), brown = live (L).
If the colors do not correspond with the
colors on your plug, identify the terminals in
your plug as follows:
1
Connect the blue wire to the terminal
marked N or colored black.
2
Connect the brown wire to the terminal
marked L or colored red.
3
Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
colored green (or green and yellow).
Before you replace the plug cover, make sure
that the cord grip is clamped over the sheath of
the cable and not just over the two wires in the
cable.
Publicité
Table des Matières
