Troubleshooting Guide - Marmitek TLV 9600 Notice D'utilisation

Troubleshooting Guide

If the unit does not operate normally when you follow the instructions indicated in the manual,
please refer to the table below.
SYMPTOM
No power. The power cord is not correctly
connected to the wall outlet.
The unit is in timer recording
stand-by mode.
No image The connections are not correct.
displayed on The power to the camera and/or
the monitor TV. monitor TV is not turned on.
The buttons do The unit is in timer recording
not respond. stand-by mode.
Alarm recording.
Panic recording.
The security lock(SET LOCK) is
engaged.
Unit will not go The loaded cassette has no
into record erasure prevention tab.
mode.
Autorepeat. "NO" is selected for autorepeat
recording in the REC MODE SET
menu.
During autorepeat recording
when there is an alarm input,
autorepeat recording is canceled.
Timer The date and time are not
recording. correct.
The unit is not set to timer
recording stand-by mode.
"N" is selected for the TIMER
PROGRAM SET.
POSSIBLE CAUSE
35
CORRECTIVE ACTION
- Connect the power cord firmly into
the walloutlet.
- This is normal, not a malfunction.
- Check that all connections are correct.
- Turn all connected devices power
on.
- Press the POWER/Timer button.
- Wait for the alarm recording to end.
- Press the STOP button for 3
seconds to stop.
- Wait for the panic recording to end.
- Press the STOP button for 3
seconds to stop.
- Cancel the security lock.
- Load a cassette tape with
erasure prevention tab or cover
the tab hole with adhesive tape.
- Be sure to select "YES" for
autorepeat recording.
- Set "YES" again for autorepeat
recording.
- Set the date and time correctly.
- Press the POWER/TIMER button to
display " " on the display panel.
- Be sure to select "Y" for the
TIMER PROGRAM SET.