Connecting Inverter Cables; Operating Instructions - Schumacher Electric PID-410 Guide D'utilisation

4.

CONNECTING INVERTER CABLES

The inverter and power source must be in the OFF mode.
Inverter connection:
1. Locate the positive and negative plastic terminals located on the back of
the inverter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
Connecting inverter cable to a vehicle (100 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
Connecting inverter cables to 12v battery or 12v power source:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the positive (red) inverter terminal cable to the power source
positive (+) or battery terminal. Make sure the connection is secure.
4.
Connect the negative (black) inverter terminal cable to the power source
negative (-) or battery terminal. Make sure the connection is secure.
5. To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the inverter is being
connected to or disconnected from the 12-volt power source.
and permanent damage to the inverter.
5.

OPERATING INSTRUCTIONS

1. Connect the inverter (see "CONNECTING INVERTER CABLES" section.
2. Make sure the device to be operated is turned OFF.
3. Plug the device into the inverter AC outlet.
4. Press and hold the ON/OFF switch to turn the inverter on. (The internal
speaker will make a brief "beep". This is normal.) The Watts LED will glow
and the digital display will show .
Make sure you connect your inverter to a 12-volt power supply only.
Failure to make the correct connections will result in blown fuses
• 10 •