Connecting Inverter Cables; Operating Instructions - Schumacher Electric PID-760 Guide D'utilisation

The inverter and power source must be in the OFF mode.
IMPORTANT: Make sure to connect your inverter only to a 12 volt power supply.
INVERTER CONNECTION:
1. Locate the positive and negative plastic terminals on the right side of the
inverter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) terminal screw.
Install the negative (black) cable ring lug onto the negative (black) terminal
screw. Tighten each terminal so that the cable cannot come loose.
CONNECTING INVERTER CABLE TO A VEHICLE (100 watts maximum):
1. Remove the cigarette lighter from its outlet.
2. Push the 12 volt power plug firmly into the outlet.
CONNECTING INVERTER CABLES TO 12V BATTERY OR 12V POWER
SOURCE:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the negative (black) inverter terminal cable to the power source
negative (-) or battery terminal. Make sure the connection is secure.
4. Connect the positive (red) inverter terminal cable to the power source
positive (+) or battery terminal. Make sure the connection is secure.
5. To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the inverter is being
connected to or disconnected from the 12 volt power source.
CAUTION: Failure to make the correct connections will result in blown fuses and
permanent damage to the inverter.
1. Connect the inverter (see Connecting Inverter Cables section).
2. Press and hold the ON/OFF switch to turn the inverter on. (The internal
speaker will make a brief "beep". This is normal.)
3. The digital display turns on.
4. Make sure the device to be operated is turned OFF.
5. Plug the device into the inverter AC outlet.
6. Turn the inverter on. The Watts LED will glow and the digital display will
show O.
7. Turn the device on. The display will now show the total wattage used by the
device. To change the digital display, press the ON/OFF switch.

CONNECTING INVERTER CABLES

OPERATING INSTRUCTIONS

• 8 •