Invacare 6291 Série Manuel D'utilisation page 4

3 Usage
3.1 Opening/Folding the Walker
WARNING
Pinch points exist between the frame
tubes when opening and folding the
walker. Make sure hands and body are
clear of all pinch points.
1. Swing both side frames (A) out away from the front
crossbrace (B) until an audible "click" is heard and
both locking mechanisms (C) engage.
WARNING
BEFORE use, both sides of the walker
MUST be open and in locked position.
2. Test the walker by grasping the side frames (A) and,
with some force, try to fold them inward.
3. To fold the walker, press down on the locking
mechanisms (C) and fold the side frames (A) in
toward the front crossbrace (B).
3.2 Installing/Adjusting Leg Extensions
WARNING
The walker MUST be level before use.
When using wheeled attachments on the
front legs, the rear leg extensions MUST
be adjusted to make the side frames level.
Pinch points exist when installing and
adjusting leg extensions. Make sure hands
and body are clear of all pinch points.
Wheeled leg extensions MUST be
installed with the wheels on the outside
of the walker.
1. Press the snap button and slide the leg extension
(D) onto the walker leg.
2. Adjust the leg extension to the desired height and
allow the snap button to snap into the height
adjustment hole.
 An audible "click" will be heard.
3. Repeat STEPS 1 and 2 as necessary.
4. Make sure that the walker is level.
Dual Release Walkers
LOCKING MECHANISM
LEG EXTENSION SNAP BUTTON
Leg
Extension
Snap Button
(fully engaged)
Correct
Snap Button
(not engaged)
4
C
B
DETAIL "A" -
Engaged (up)
Not engaged (down)
DETAIL "B" -
Incorrect
Part No 1167481
A
D