Avocent DSR1030 Guide D'installation Et D'utilisation page 38

28
DSR Switch Installer/User Guide
4. Type the first few characters of a target device name or port number to scan. The first matching
target device will appear in the line.
-or-
Press the following keyboard commands in the Name, Port or Time column to move through
the list of target devices available to scan.
a. Press
b. Press
c. Press
d. Press
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press
remaining target devices to be included in the scan pattern.
7. Click OK.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press
Delete
-or-
Press
Shift+Delete
3. Click OK.
To start the Scan mode:
1. If the OSCAR interface is not open, press
2. Click Commands. The Commands dialog box appears.
to move the cursor down through the list of target devices.
Alt+Down Arrow
to move the cursor up through the list of target devices.
Alt+Up Arrow
to move the cursor to the first target device in the list.
Alt+Home
to move the cursor to the last target device in the list.
Alt+End
.
to remove the selected target device and all entries below it.
and repeat steps 2-5 for each of the
Down Arrow
The Main dialog box will appear.
Print Screen.