Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting up your network
The DSR switching system uses IP addresses to uniquely identify the switch and the target devices.
The DSR switch supports both Dynamic Host Configuration Protocol (DHCP) and static IP
addressing. Avocent recommends that IP addresses be reserved for each switch and that they
remain static while the DSR switches are connected to the network. For additional information on
setting up the DSR switch using the DSView Server software, and for information on how the DSR
switch uses TCP/IP, see the DSView Installer/User Guide.
Getting Started
Before installing your DSR switch, refer to the following lists to ensure you have all items that shipped
with the DSR switch, as well as other items necessary for proper installation.
Supplied with the DSR switch
•
Local country power cord
•
Rack mounting brackets
•
Null modem cable
•
DSR Installer/User Guide (this manual)
•
DSR Quick Installation Guide
Additional items needed
•
One DSRIQ module per target server or DSRIQ-SRL module per serial device
•
One CAT 5 patch cable per DSRIQ module (4-pair UTP, up to 10 meters)
•
One CAT 5 patch cable for network connectivity (4-pair UTP, up to 10 meters)
•
One USB2 or USB2L DSRIQ module per target server for virtual media sessions
•
DSView software
•
(Optional) V.34, V.90 or V.92-compatible modem and cables
•
(Optional) SPC power control device
Chapter 2: Installation
7
Publicité
Chapitres
Table des Matières
