Settings Via Circuit Board Controller; Adjusting The Water Temperature - Jaga Mini Canal Hybrid Manuel D'installation

7. SETTINGS VIA CIRCUIT BOARD CONTROLLER
7.1. ADJUSTING THE WATER TEMPERATURE
The unit starts from the set temperature
7.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster.
1. Start setup mode: hold the [-] button until
2.
1
-
The blue LED flashes quickly as soon as the minimum
temperature is reached.
Automatic control: The green LED
rature.
3. Exit setup mode: hold the [-] button until
7.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster.
When using a heat pump, it may be necessary to set the water temperature at a lower setting.
1. Exit setup mode: hold the [+] button until
2.
1
-
The blue LED flashes quickly as soon as the minimum
temperature is reached.
Automatic control: The green LED
rature.
3. Exit setup mode: hold the [+] button until
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode.
MINI CANAL HYBRID | MANUAL | 09 06 2020, 09:44
/
20
- +
the
Briefly press the [-] or [+] button to adjust the set tempe-
10 sec
12 ̊ C 14 ̊ C 16 ̊ C 18 ̊ C
lights up when the water temperature (supply water) is lower than the set tempe-
the
- +
the red LED
Briefly press the [-] or [+] button to adjust the set tempe-
10 sec
24 ̊ C 26 ̊ C 28 ̊ C 30 ̊ C
lights up when the water temperature (supply water) is lower than the set tempe-
the red LED
.
28
blue LED flashes 5x and release.
rature.
20 ̊ C 22 ̊ C 24 ̊ C
The red LED flashes quickly as soon as the maximum
blue LED flashes 5x and release.
flashes 5x and release.
rature.
32 ̊ C 34 ̊ C 36 ̊ C
The red LED flashes quickly as soon as the maximum
flashes 5x and release.
1
-
26 ̊ C
temperature is reached.
1
-
38 ̊ C
temperature is reached.
- +
EN
- +
59