Publicité
Les langues disponibles
Les langues disponibles
ii. Power on the TV Transmitter. Insert the TV Transmitter's USB plug into your
TV's USB port, or supplied USB power adapter.
iii. The TV Transmitter's LED will cycle between lit for several seconds and unlit for
1 second.
iv. This confirms that your power setup for the TV Transmitter is good. Note that
anytime you power on the TV Transmitter without a 3.5mm cable connected,
its LED will show this same pattern.
c) Setup the TV Transmitter for use with your TV:
i.
Insert the optical cable into your TV's optical port or insert the coax cable into
your TV's digital audio coax port.
ii. Power on the TV Transmitter. Insert the TV Transmitter's USB plug into your
TV's USB port or supplied USB power adapter.
iii. The TV Transmitter's LED will remain unlit. Note that anytime you power on
the TV Transmitter without a 3.5mm cable connected, its LED will show this
same pattern.
d) Play some audio on your TV by watching a TV show or video.
i.
Put Soul Bar in SKAA receive mode.
ii. Double-click the bond button on Soul Bar. The Soul Bar's SKAA Bond LED sta-
tus indicator should turn bright amber and you will hear your audio playing.
iii. Press and hold the bond button for 3 seconds to add your Levven Audio TV
Transmitter to the Soul Bar's green list. The SKAA Bond LED will turn bright
green.
iv. Press Soul Bar's bond button four times to put Soul Bar into swing mode. The
SKAA Bond LED will turn bright red.
4.3.1
INFRARED REMOTE SETUP
You can use your favorite infrared remote control with the TV Transmitter. The TV Trans-
mitter has an intelligent learning ability to recognize and save new IR remotes.
Using your TV's infrared (IR) remote control, you can increase, decrease, or mute the vol-
ume through the Levven Audio TV Transmitter.
Follow these instructions to setup this feature:
a) Prepare by having your favorite infrared remote control near at hand.
b) Power off the TV Transmitter by removing the USB plug from the TV's USB port, or
from the supplied USB power adapter.
c) Remove the optical or coax audio input cable from the TV Transmitter's 3.5mm jack.
The IR learning is initiated when the TV Transmitter is powered on without the audio
cable.
d) Power on the TV Transmitter. Insert the TV Transmitter's USB plug into the TV's USB
port, or the supplied USB power adapter.
e) The TV Transmitter's LED will flash twice when powered up to indicate learning has
started.
f) Point your remote to the front of the TV Transmitter and press and release the follow-
ing remote-control buttons in order:
i.
Volume Up
ii. Volume Down
iii. Mute
g) After each press and release, the TV Transmitter's LED will briefly flash.
h) After pressing mute on your remote control, the TV Transmitter's LED will stay on solid
for 2 seconds, confirming that the learning process was completed successfully.
i)
Reconnect the optical or coax audio cable to the TV Transmitter's 3.5mm audio input
8
Publicité
