Levven LA-SR50 Instructions De Fonctionnement page 5

SKAA Bond
LED
3.4.6 BLUETOOTH BUTTON
Bluetooth
LED
Gear SKAA Bond
3.4.7 RELAY LED
Button Button
Bluetooth
LED LED
3.4.8 VOLUME UP (+) BUTTON
SKAA Bond Bluetooth
Button
3.4.9 VOLUME DOWN (-) BUTTON
Bluetooth
Button
3.5 MOUNTING TO A WALL
Bluetooth
3.5.1
Button
3.5.2 INSTALLING SOUL BAR
3.6 AC POWER INPUT
Soul Bar will operate between 100-240 AC line voltage with a line frequency of either 50 Hz or 60
Hz. There is no need to convert or adjust the unit in any way.
Note: If you are going to be away from home for an extended period such as a month-long
vacation, it is a sensible precaution to unplug it (as well as other audio and video components)
while you are away.
Bluetooth
LED
Relay
Click this button to attempt a connection to a Bluetooth device. Hold this button for 2 to
LED
drop the active Bluetooth connection and enter the Bluetooth pairing state. A ten-second
hold will clear the Bluetooth paired list and enter the Bluetooth pairing state.
Bluetooth
Button
Relay
LED
When on solid and bright, this blue LED indicates Soul Bar is in Bluetooth relay mode.
Volume -
Button Button
Click this button to increase Soul Bar's receiver volume.
Volume - Volume +
Button Button
Click this button to decrease Soul Bar's receiver volume.
Volume -
INSTALLING THE BRACKETS
Button
Soul Bar includes two (2) wall mounting brackets and four (4) screws per bracket. For
safety reasons, mount the Soul Bar at a maximum height of 2 m (6 ft) above the floor. Re-
member to account for the length of the power cord when choosing a mounting location
on the wall.
Install the brackets to the wall. Locate a stud (structural framing member) in the wall
and position the brackets so that at least 2 screws install into the stud. This will ensure a
safe and secure wall mounting. If you cannot position Soul Bar near a stud, use drywall
anchors rated for 10 kg (22 lbs) or greater. For safety reasons, make sure to install all four
screws in each bracket.
First make sure the AC power cord is disconnected from the wall outlet. Install the AC
power cord into Soul Bar. Position Soul Bar over the brackets that are installed on the wall
and gently lower Soul Bar onto the brackets.
Relay
LED
Volume - Volume +
Button
Volume +
Button
Volume +
Button
Button
5