Hatco HWBI Série Manuel D'installation page 21

English
Pan Support Bars
The following pan support bars are available to divide the
heated wells into sections for different size pans.
HWBGM12BAR ....12" (305 mm) Pan Support Bar
HWBGM20BAR ....20" (508 mm) Pan Support Bar
(not available for HWBI43 models)
12" Pan Support Bars
Pan Support Bars
Well Covers
Well covers are available as accessories and are constructed
of a simulated stone solid surface. Well covers convert the well
to a heated shelf when placed on top of a well unit. They are
available in one- or two-well cover sizes and in several color
options.
Before turning on the unit each day, clean and sanitize the stone
surfaces using a clean, damp cloth and a sanitizer approved for
food contact surfaces.
One-Well Cover
Well Covers
Side Mounted Auto-Fill
The side mounted Auto-Fill option connects the on-site water
supply through the control panel to an Auto-Fill fitting on the
side of the well enclosure. Use the following procedure to install
a unit equipped with the side mounted Auto-Fill option.
NOTE: The Plumbing Kit that comes with this unit includes the
following parts: street elbow, back-flow preventer valve,
fill tube hose, and hose clamps. For a detailed image of
the Plumbing Kit, refer to "Drain Mounted Auto-Filll" in
this section.
CAUTION
Auto-Fill units must be installed with adequate backflow
protection and must conform with all federal, state, and
local codes.
NOTICE
Auto-fill units supplied with water from a reverse osmosis
(RO) system (or similiar water filtration system) must be
installed with an operating reminerialization sytem to
ensure proper operation. Failure to do so may cause unit
to overfill. Damage caused by overfilling is not covered
under warranty.
Form No. HWBIM-0820
20" Pan Support Bar
Two-Well Cover
OPTIONS AND ACCESSORIES
Drain sealants must have temperature rating of 500°F (260°C)
or higher. Incoming water pipes must be FDA compliant for
potable water.
1. Connect the street elbow to the Auto-Fill fitting located on
the outside of the well. Replace the fill tube hose on fitting.
NOTE: The fill tube hose may need to be removed from the
Plumbing Kit for ease of installation.
2. Connect the fill tube hose to the fill valve nipple in the
control enclosure and secure using the hose clamp.
(Disassemble the control enclosure trim cover to access
the nipple.)
3. Connect the on-site water supply line to the 1/4" NPT water
inlet fitting on the control enclosure.
4. Turn on the water supply and check for leaks.
Back-flow
Preventer
Valve
Water Inlet
Fitting
Fill Tube
Hose
Water
Inlet
Fitting
Fill Valve
Nipple
Hose
Clamp
Fill Tube
Installing a Side Mounted Auto-Fill Unit
NOTE: Refer to "Water Supply Specifications" in the
SPECIFICATIONS section of this manual for water
supply requirements.
21
NOTICE
Auto-Fill Fitting
Street Elbow
Hose