Hatco HWBI Série Manuel D'installation page 11

English
Insert bracket
into slot in
EZ locking tab.
Thick Countertop Adapter Bracket
6. Carefully trim and remove the excess ribbon putty material
from around the unit.
7. Install the control enclosure(s). Refer to the "Installing a
Remote Control Enclosure" procedure in this section.
Built-In Stud Mounting System
NOTE: This type of installation is not available for HWBI43
models.
NOTE: Cut the opening for both the unit and the control
enclosure(s) before placing unit into the countertop
opening.
1. Cut the appropriate opening in the countertop and drill
holes for the mounting studs. Refer to the appropriate
"Countertop Cutout" chart in this section.
2. Cut the appropriate opening for the control enclosure(s)
Refer to the "Control Enclosure Cutout Dimensions" chart
in this section.
3. Place ribbon putty gasket around the cutout edge of the
countertop. Make sure the ribbon putty gasket overhangs
the cutout edge or seal unit with silicone adhesive.
NOTE: A roll of ribbon putty gasket material is supplied with the
unit.
Built-In Stud Mounting
Form No. HWBIM-0820
Tighten bolt against
underside of
countertop.
Adapter
Bracket
Bolt
(included
with bracket)
Mounting
Stud
Mounting
Stud
Mounting
Nut
4. Place the unit into the countertop opening and secure with
1/4-20 mounting nuts on the mounting studs. Tighten the
nuts securely.
5. Carefully trim and remove the excess ribbon putty material
from around the unit.
6. Install the control enclosure(s). Refer to the "Installing a
Remote Control Enclosure" procedure in this section.
Through-Hole Mounting System
NOTE: This type of installation is not available for HWBI43
models.
NOTE: Cut the opening for both the unit and the control
enclosure(s) before placing unit into the countertop
opening.
1. Cut the appropriate opening in the countertop and drill
corresponding mounting holes. Refer to the appropriate
"Countertop Cutout" chart in this section.
2. Cut the appropriate opening for the control enclosure(s)
Refer to the "Control Enclosure Cutout Dimensions" chart
in this section.
3. Place ribbon putty gasket around the cutout edge of the
countertop. Make sure the ribbon putty gasket overhangs
the cutout edge or seal unit with silicone adhesive.
NOTE: A roll of ribbon putty gasket material is supplied with the
unit.
4. Place the unit into the countertop opening and secure with
mounting hardware (not supplied).
Through-Hole Mounting
5. Carefully trim and remove the excess ribbon putty material
from around the unit.
6. Install the control enclosure(s). Refer to the "Installing a
Remote Control Enclosure" procedure in this section.
11
INSTALLATION
Mounting Hardware