Shure LensHopper VP83 Guide De L'utilisateur page 6

Troubleshooting
Issue Solution
Unit does not turn on Replace batteries and make sure that the batteries are installed
correctly.
Sound is distorted • Check that the audio cable is completely inserted into the camera.
• Camera input gain may be set too high, resulting in clipping. Try
lowering the gain. If the camera's gain appears to be adjusted
properly, try setting the gain switch set to 0 or -10 dB.
• If listening through headphones, check the connection or try using
a different pair.
No sound • Make sure the microphone is on and that the audio cable is
connected to the correct audio input jack on the camera.
• If the camera doesn't register a signal, try increasing the camera
gain or setting the gain switch to +20.
Accessories and Replacement Parts
Rycote replacement foam windscreen
®
Rycote Windjammer™
®
Certifications
Note: Testing is based on the use of supplied and recommended cable
types. The use of other than shielded (screened) cable types may degrade
EMC performance.
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
A83W
A83-FUR
6