Table des Matières
Publicité
Installation Method
■ Installation procedure
1
Remove the special screws (2 locations) from the
bottom of the hung on wall unit.
Special screws (M6)
2
Remove the hardware on the wall side and the
hardware on the PDP side.
PDP side hardware
3
Attach the PDP side hardware to the plasma
display.
Warning
• Cover the display with a sheet or similar protective material
to protect it from scratches or other damage.
• Be sure to attach it on top of a flat table or similar surface.
Plasma display
Top side of plasma display
4
Fix the plasma display to the PDP side hardware
with bolt M8 (6 locations). Usually, use the holes
marked with the red triangle "∆".
Top side of plasma display
Wall side hardware
PDP side hardware
Warning
Be sure to install the speaker at this stage.
･For the installation method, refer to the speaker installation
procedure in the speaker user manual.
5
Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations)
symmetrically on the left and right side (one at
each location from the center of the
Because the screws and bolts used to do this
are different according to the wall strength and
wall material, purchase suitable screws and
bolts separately.
Warning
Check the strength of the wall and beams before installing the
display.
6
Attach the hook on the PDP side hardware to the
wall side hardware.
Warning
Do not hold the speakers during the installation work.
7
Fix the bottom of the hardware with the special
screws removed at step 1 (one on the left and
one on the right).
Special screw (M6)
).
43
Publicité
Table des Matières
