Table des Matières
Publicité
Stand assembling
■ Assembling Steps
1.
Turn the base cover over so the underside
is facing up.
2.
Insert the stand pipes into the base cover.
3.
Use the included screws to stabilize the
stand pipes.
Stand attaching to the Plasma Display
■ Normal Installation
Step 1. With the plasma display lying flat, insert and secure the two Installation bolts 1 (M8 x 20) in the holes "a" located in the
plasma display housing.
At this point, tighten these bolts 1 only until the threads are no longer visible when viewed from t he side (you will be
unable to attach the display if the bolts are screwed in completely).
Plasma display
◆ ◆ Regarding the stand pipe screw holes when the stand is used as a desktop stand
C
B
A
C ´
B ´
A ´
Installation bolt 1 (M8 x 20)
Holes "a"
(holes in center of plasma display)
C
B
Normal use
A
C ´
With optional speakers attached to
B ´
A ´
both sides of display
Screws (4 x 8)
Stand pipe
Base cover
Installation bolt 1
Screw holes used with
Specifications
stand orientation
Screws (4 x 8)
Stand pipe
Plasma display housing
Stop screwing down the bolt
when the threads are no
longer visible.
B, B'
35
Publicité
Table des Matières
