KRONAsteel AMELI Série Mode D'emploi page 10

EN Application sheet
The model name and important technical charac-
teristics of the kitchen hood are specified inside
the case.
Security measures
The kitchen hood is connected to the power net-
work with the voltage of 220/240 V – 50 Hz, using
a wall outlet with earthing only. The kitchen hood
has 1 electrocution protection class.
Use the light bulbs with the voltage no higher
than specified in the Instructions.
It is forbidden to operate the kitchen hood with-
out an aluminum grease filter.
The air from the kitchen hood should be removed
to the air shaft only (its removal to the chimney is
strictly forbidden).
SAFETY OF CHILDREN
Children often do not understand the danger of
electrical appliances. While the kitchen hood is
functioning, watch your children and do not al-
low them to work with it. Packaging materials
(such as polyethylene film) may cause suffoca-
tion. Keep them out of reach of children
RANGE HOOD DESCRIPTION
External part of the range hood consists of the fol-
lowing main parts (see Figure 1):
1. Operating mode selector.
2. Built-in part of the body.
3. Removable decorating panel.
4. Reusable aluminum grease filter.
5. Protective lamp glasses.
Range Hood Accessories:
Carbon Acrylic Odor Filter (to be purchased by the
user additionally) (see Figure 2), which is used
for filtering air in the room in the Circulation Mode.
Available in retail outlets.
8
KITCHEN HOODS
The push-button selector of exhaust motor and
lamp operating mode is located in the bottom part
of the range hood (Figure 3) and consists of:
1. Motor ON/OFF button.
2. First exhaust speed switch on button.
3. Second exhaust speed switch on button.
4. Third exhaust speed switch on button.
5. Lamp on/off button.
Using this Mode Selector a user can switch on one
of the speeds of the exhaust fan motor. To switch
on the desired speed, simply press corresponding
speed button; to switch on another exhaust speed
press the button of the new desired speed – there
is no need in switching off the previous speed but-
ton. To switch off the exhaust motor press button #1.
You can switch on the lamps irrespectively of the
exhaust motor operation.
The sensor selector of exhaust motor and lamp op-
erating mode is located in the bottom part of the
range hood (Figure 4) and consists of:
1. First exhaust speed switch on button.
2. Second exhaust speed switch on button.
3. Third exhaust speed switch on button
4. Lamp on/off button.
Use this selector to switch on one of three exhaust
fan speeds. To switch on the desired speed, simply
touch corresponding speed button; to switch on
another exhaust speed touch the button of the new
desired speed – there is no need in switching off the
previous speed. To switch off the exhaust touch the
button of the current fan speed again.
You can switch on the lamps irrespectively of the
exhaust motor operation..
RANGE HOOD CONTROLS
Control Panel AMELI PB
Control Panel AMELI S