Recording Guitar Or Bass - Roland Edirol UR-80 Mode D'emploi

Recording audio

Recording guitar or bass

When you use your sequencer software to record your guitar playing while listening to the
playback of audio data already on your computer, only the guitar performance will be newly
recorded on the computer.
fig.guitar.e
Adjust the
input level
Adjust the
volume
Connections
The sound of the instrument connected to input jack 1 will be recorded to channel L on your
computer. The sound of the instrument connected to input jack 2 will be recorded to channel R.
Sampling frequency select switch
Set this to the same sampling frequency as selected in your recording software.
Input impedance select switch
Set this to Hi-Z.
Input sensitivity knob
Use the input sensitivity knob to adjust the input level. To obtain the best audio quality, adjust the
input sensitivity knob until the level is as high as you can get it without causing the input peak
indicator to light.
Input monitor switch
Turn the input monitor switch on and adjust the input monitor level for the signal from your
guitar or bass. This will not change the recording level.
To adjust the input monitor volume, hold down the SHIFT button and turn the TIME dial.
REC SOURCE button
Set this to ANALOG (unlit).
Other notes
Don't connect anything to input jacks you are not using.
58
Guitar/Bass
Connect to
INPUT 1/L
Set the sampling
frequency
Turn input monitor on, and
adjust the input volume
appropriately
* Input monitor level -> SHIFT
button + TIME dial
Set REC SOURCE to ANALOG
(unlit)