AEG VL 5668 S Mode D'emploi page 32

English
32
5. Unscrew the mounting ring (18) in an anticlockwise direc-
tion. Keep it ready to hand.
6. Position the rear protection grid (16) in place in accor-
dance with the recesses.
NOTE:
Please ensure that the carrying handle is facing up-
wards.
7. Turn the attachment ring (18) for the rear protection grid
(16) slightly in a clockwise direction.
8. Attach the propeller. Note the position of the guide pin
on the motor shaft.
9. Tighten the attachment screw (19) for the propeller in an
anticlockwise direction.
10. Remove the preassembled fastening screw (20) and nut
(17) from the wire mesh guard. Keep it ready to hand.
11. Attach the protective front guard (21) with the hook (1) to
the protective rear guard.
NOTE:
Ensure that the holes for the attachment screw in the
front and rear protective grille are aligned one above
the other.
12. Secure the wire mesh guard with the fastening screw (20)
and nut (17).
13. Close the attachment hooks.
Position
The ideal position is a non-slip, flat surface.
Putting into Service
Electrical Connection
• Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the device to a duly installed protective contact
socket. The POWER indicator lamp indicates that the fan
is ready for operation.
Fitting Batteries into the Remote Control
(Batteries not supplied)
• Open the lid of the battery compartment on the rear of
the remote control.
• Insert 2 MICRO batteries of type R03 "AAA" 1.5 V.
• Please ensure the correct polarity. Details can be found in
the battery compartment.
• Close the battery compartment.
NOTE:
If you are not going to use the remote control for a pro-
longed period, remove the batteries in order to prevent
them from leaking.
CAUTION:
• Used batteries should not be disposed of in the
domestic waste. Please return all batteries to a special
collection point. Your local authority will provide you
with information on this.
• Different types of battery or new and used batteries
must not be used together.
Remote Control Range
The remote control has a range of approx. 8 meters. If this
range becomes shorter, the batteries must be changed.
• To use the remote control, point it at the sensor on the
front of the switch housing.
• Make sure there are no obstacles between the remote
control and the sensor.
Use
Basic Settings
Set the blower inclination angle before starting the device.
1. Loosen the set screw.
2. Tilt the fan guard into the desired position.
3. Tighten the set screw again.
CAUTION:
The tilt angle is approx. 15 degrees.
Fan Setting
You have two options:
• Stationary
1. Shut off the device.
2. Pull the control knob upwards.
3. Use the carrying handle to place the device into the
desired position.
• Oscillating
1. Shut off the device.
2. Press the control knob.
NOTE:
The device rotates automatically in the range of
about 80 degrees.
3. To turn off the function, shut off the device and pull
the control knob upwards.
Operation
For some functions, you can operate the appliance with the
remote control as well as with the buttons on the switch hous-
ing. The buttons marked * can be found on the appliance
and on the remote control.