Noise And Vibration - Flex ID 1/4 18.0-EC Notice D'instruction D'origine

 Under no circumstances open the
charger. In the event of a fault, take it to an
authorised repair shop.
 Do not place any objects on the charger
and do not place the charger on soft
surfaces. Fire hazard!
Special safety instructions
 Before carrying out any work on the power
tool, move the direction preselector
switch (2) to the middle position.
 Operate the direction preselector
switch (2) or torque setting turning
dial (5) only when the tool is stopped.
 Identify the power tool with stickers only.
Do not drill any holes into the housing.

Noise and vibration

NOTE
The noise and vibration values have been
determined in accordance with EN 62841.
The values are set out in the "Technical
data" table.
WARNING!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a measurement method
standardised in EN 62841 and may be used
to compare one tool with another. It may be
used for a preliminary assessment of
exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting
accessories or poorly maintained, the
vibration emission level may differ.
This may significantly increase the
exposure level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary to
take into account the times when the tool is
switched off or running but not actually in use.
This may significantly decrease the exposure
level over the total working period.
16
IW 1/2" 18.0-EC / ID 1/4" 18.0-EC / IW 3/4" 18.0-EC
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the cutting
accessories, keep the hands warm,
organisation of work patterns.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).