Flex ID 1/4 18.0-EC Notice D'instruction D'origine page 21

IW 1/2" 18.0-EC / ID 1/4" 18.0-EC / IW 3/4" 18.0-EC
– An LED lights up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
IW 3/4" 18.0-EC
3. Press mode switch briefly
– Two LEDs light up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
IW 3/4" 18.0-EC
4. Press mode switch briefly
– Three LEDs light up – torque:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
IW 3/4" 18.0-EC
5. Press mode switch briefly
– An LED lights up – torque switches
back to:
IW 1/2" 18.0-EC:
ID 1/4" 18.0-EC:
IW 3/4" 18.0-EC
Torque can be increased again as described.
During reverse operation of the electric tool
– which only has one speed – the LEDs in
the base go out automatically.
Change single impact mode to impact
driver mode (ID 1/4" and IW 1/2" only)
 Press mode switch for approx.
1.5 seconds.
– LED mode indicator lights up – single
impact mode active
– LED mode indicator not lit – impact
driver mode active.
Working with the power tool
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
150 Nm / 1500 rpm
60 Nm / 1500 rpm
300 Nm / 900 rpm
180 Nm / 2000 rpm
105 Nm / 2000 rpm
590 Nm / 1000 rpm
250 Nm / 2500 rpm
225 Nm / 2500 rpm
1060 Nm / 1700 rpm
150 Nm
60 Nm
300 Nm
NOTE
To facilitate handling of the appliance when
inserting screws, the screwdriver bit can be
inserted directly into the tool holder of the
appliance.
1. Assemble the tool head (drill chuck, angle
attachment, bit holder attachment).
2. Insert the battery.
3. Insert the tool (drill bits, srewdriver bits,
bit holders).
4. Set torque preselection to the required
setting.
5. Set the required direction of rotation.
6. Hold the power tool with one hand on the
handle and assume the working position.
If the power tool is running, never actuate
the direction preselector switch or torque
setting turning dial.
7. Switch on the power tool.
At the end of work:
8. Release the trigger switch.
9. Move the direction preselector
switch (2) to the middle position.
21