Placement And Installation; Choosing The Right Place; Installation; Applications - Summit SBC635MBI Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

To ensure that your beer dispenser works at the maximum efficiency it was designed for, install

it in a location where there are proper air circulation and electrical connections.

Choose a location where the beer dispenser will be away from any heat sources and will not be

exposed to direct sunlight.

Remove all packing materials before using the beer dispenser.

Place the machine on a smooth, flat and sturdy surface.

CAUTION:

After unpacking, you MUST allow this appliance to stand upright for at least 2 hours to

allow the lubricant and refrigerant to drain back into the compressor and stabilize.

Failure to do so may adversely affect performance and the lifetime of the unit.

Model SBC635MOS is suitable for both indoor and outdoor use, while Model SBC635MBI is

designed for indoor use only. Both models can be installed either built-in or free-standing. For

built-in installation, you must provide the following clearances around the unit for best operation

and proper ventilation: 3/16" on both sides, 2" at the rear and 1/16" at the top. Take care that the

air vent at the front of the beer dispenser is never covered or blocked in any way. For free-

standing installation, make sure you allow at least 4" of clearance at the sides, rear and top to

allow for adequate airflow. Be sure no air vents are blocked.

The SBC635MBI and OS beer dispensers meet UL Standards 250 and 471 and are suitable for

residential or commercial use. Models with "7" in their name are ETL-S listed to NSF-7

sanitation standards.

Connect the appliance to a 3-prong power supply socket (which has a ground terminal).

only have a two-prong outlet, have it replaced by a qualified technician with an outlet that meets

the local codes

Required nominal voltage and frequency are indicated on the rating plate. The connection to

the power supply and grounding has to be made according to current standards and

regulations. The appliance resists temporary voltage fluctuations with a tolerance of ±10%.

Outdoor model SBC635MOS is fitted with a GFCI safety plug to prevent short circuits during wet

conditions.

Once connected, allow the appliance to operate empty for two to three hours before putting a

beer keg inside.