Reversing The Door Swing - Summit SBC635MBI Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Figure 1 (Default position)
The beer dispenser can be opened from either the right side or the left. By default, the door
hinge is on the right side. If you prefer it on the left, please follow these instructions:
Note: All of the parts that are removed must be kept for the reinstallation of the door.
1.
Remove the three screws (6) holding lower door hinge (5). Keep hinge for later use.
2.
Remove the door from the upper hinge (3), and keep the padded surface upward to prevent
scratching.
3.
Remove the upper hinge cover (1), remove the two screws (2), remove the upper hinge (3)
and keep it for later use.
4.
Remove the hole cover (7) and transfer it to the same location on the opposite side.
5.
Insert the lower door hinge (5) into the left side, fixing the hinge into place by tightening all
the screws (6).
6.
Remove the pin cap (9) from the left side of the upper door frame and then transfer it to the
same location on the opposite side.
7.
Set the door on the lower door hinge (5), keep the door level, then fix the upper hinge (3) to
the body (8) by the screws (2).
8.
Put on the upper hinge cover (1).

Reversing the Door Swing

1. Upper hinge cover
2. Screws
3. Upper hinge
4. Door
5. Lower door hinge
Figure 2 (After door reversal)
6. Screws
7. Hole cover
8. Cabinet
9. Pin cap
8

Publicité

Chapitres

Table des Matières
loading

Table des Matières