Location Of Parts; Before Using For The First Time - Summit SBC635MBI Mode D'emploi

Top cover
Cabinet
CO regulator valve
2
CO gas cylinder
2
CO tank supporter
2
Control board device
Compressor
chamber cover

BEFORE USING FOR THE FIRST TIME

The SBC635M series is designed for dispensing beer only, and is not recommended for
storing perishable foods such as meats or dairy products.
Before connecting the appliance to the power supply, leave it standing for 2 to 3 hours
This allows the refrigerant to drain back into the compressor and reduces the risk of
malfunctions in the cooling system caused by shipping.
Clean the appliance thoroughly, especially the interior. (See Maintenance of the Beer
Dispenser.) Proper grounding must be ensured to reduce the risk of shock and fire. Do
not cut or remove the grounding plug!
Try not to open the door too often, especially when the weather is hot and humid. Once
you open the door, try to close it as soon as possible.
If possible, disconnect the power before changing a keg of beer.
Keep the unit out of direct sunlight.
Periodically, check that the beer dispenser seals well and that none of the contents
prevent the door from closing.

LOCATION OF PARTS

TIPS FOR SAVING ENERGY
4
Beer tower assembly
Upper cover guardrail
Drip tray
Display and control
panel
Evaporator
Ball valve
Beer keg
Door
Bottom pad
Caster
.