Auxiliary Supply; Factory Settings - IME Nemo 96 HDLe Mode D'emploi

Auxiliary Supply

Terminals 20 and 21
Auxiliary supply direct or alternating current electrical supply which is necessary for
proper working of the device.
Please verify that the available supply voltage meets the one shown on the data label of
the meter (voltage value and any frequency).
Where a double voltage is shown (for instance 80...265Vac / 100...300Vdc) the meter can be
fed with alternating voltage 80...265Vac or direct voltage 100...300Vdc.
In case of direct voltage supply please respect the shown polarities
INPUT
CURRENT Rx / Tx GND
VOLTAGE
+ –
11 9 3 4
2 5 8 1 3 4 6 7 TI T2
02/18 E08 10782668 WEB E cod.MF964..
20+ and
RS 485
AUX.
SUPPLY
+ –
5 21
20
F : 1A gG
F
Factory setting
Password 1000
Customized page
1 Lin1v voltage 1
Lin2v voltage 2
2
3 Lin3v voltage 3
Connection: 3n3E 4-wires 3-system line
verage time:
Contrast: 03 level 3
21-.
Backlight: 30%
Rated frequency:
Rated current:
Run hour meter:
RS485
Address: 255
Speed: 9.600
Parity: none
Time: 20ms
Word: bend
Pulse output
Energy: active
Pulse weight: 0,01kWh
Width of the pulse: 50ms
Harmonic display:
Password 2001
CT ratio: 0001 direct connection
VT ratio: 01,00 direct connection
Password 3002
Protocol: MdbS Modbus RTU
5m 5 minutes
50Hz
5A
U Voltage start
up to the 9 th harmonic
Nemo 96 HDLe
19