Baumatic BHG710SS Manuel D'instructions page 37

VENTILATION OF ROOMS
The room in which this appliance is installed must be well ventilated by natural or mechanical
means, or a combination of both to ensure correct combustion and the removal of spent air. The
minimum quantity of air for combustion will depend on the room volume, number of appliances and
their total power rating. The power rating of your appliance can be found by reference to the Rating
Plate.
Note: The actual ventilation requirements must be determined by reference to the Statutory
Regulations in force.
GAS CONNECTION
The gas supply must be connected by use of the _ BSP Elbow, Seal and copper pipe and an
isolation tap fitted in an easily accessible position. The appliance as supplied is for use with Natural
Gas, if it is to be adapted for LPG proceed as follows:
Isolate the appliance from the electricity and gas supplies.
Remove the pan supports and burner assemblies.
Replace the injectors with the alternative type supplied.
Use the appropriate thread sealant and check for gas soundness.
Affix the self-adhesive label to the Rating Plate to amend the Gas Category.
Fig. 2
ELBOW
33
INSTALLATION INSTRUCTIONS
Fig. 3
INJECTOR