Baumatic BHG710SS Manuel D'instructions page 36

This appliance must be installed by a competent person in accordance with the current version of
the following UK Regulations and Safety Standards or their European Norm Replacements:
NOTE: UK law stipulates that gas appliances must be installed and repaired by a CORGI
Registered Installer (all Baumatic Engineers are CORGI Registered).
Gas safety Regulations (Installation & Use)
Building Regulations (issued by the Department of Environment)
Building Standards (Issued by the Scottish Development Department)
IEE Wiring Regulations
Electricity at Work Regulations
BS 6172 Installation of Domestic Gas Cooking Appliances (if necessary, BS 5482
Installation of Domestic LPG Appliances)
BS 5440 Installation of Flues and Ventilation for Gas Appliances
Baumatic Ltd Installation Instructions
This appliance is classified as Class 3 and therefore is to be built into a kitchen unit (depending on
size) or 600mm wide worktop, providing the following minimum distance is allowed:
700mm between the top surface and the underside of any horizontal surface above it.
50mm clearance around the appliance and combustible materials.
The surface finish of any adjacent unit must be capable of withstanding a minimum temperature of 85°C.
When unpacked, check that the following parts are included with the appliance:
Baumatic Ltd Instruction and Installation Book
Pan Supports
Burner Assemblies
Adhesive sealing strip and fixing clamps & screws
½ BSP Elbow & Seal
LPG conversion kit comprising an LPG jet for each burner and a self-adhesive label for
amending Gas Category on the appliance Rating Label.
1. Cut the aperture to the dimensions shown below or use the template if printed on the packaging.
2. Invert the Hob and apply the sealing agent provided to match the outer perimeter edge.
3. If the sealing agent is a strip type, the protective covering must be removed from both sides.
Do not leave a gap in the sealing agent or overlap the thickness.
NOTE: do not use any Silicone based sealant, as this can damage the worktop surface if
repairs are required.
4. Insert the appliance into the aperture and fix in position via the clamps & screws, tightening the
screws evenly (see Fig. 1 below).
5. If the appliance is to be installed in a Leisure Accommodation Vehicle, the requirements of EN
721 must be applied.
32