RHOSS KMSR Mode D'emploi page 41

The sequencer invitation parameters are displayed in the input/output
status menu, specifically:
!
ALARM
Prg
ON
OFF
Display Description
Virt. probe Value of the virtual adjustment probe
Virt. set System set point
Virt. band
Unit proportional band calculated by RMST
If the system has been set on OFF from the Sequencer, the chiller
display shows the following screen
!
ALARM
Prg
ON
OFF
Z-Power / Y-Power / Y-Flow EXP / EXP range
Enter the Configuration menu BMS.
In I01a mask set:
Type supervisor : Rhoss Sequencer
Lon factor:
BMS table:
Set the port on the BMS protocol RHOSS, speed 19200, NONE parity
and 2 stop bits.
The serial addresses must be unique and must be assigned
consecutively (1-10) to the individual units sequenced.
For more information on using the on-board display of individual units
refer to the manual H57850 - Electronic controls.
MODE
MODE
No
#0
Section I :: User
41
EN