Safety And Emc Instructions; Important; Transportation And Storage; Preparation - INFOSEC UPS SYSTEM E4 LCD Evolution 5000 Manuel De L'utilisateur

1. Safety and EMC instructions

Please strictly comply with all operating instructions in this manual strictly. Keep this
manual in a safe place and read the following instructions carefully before installing
the unit. Do not operate this unit before carefully reading all warnings and operating
instructions.

IMPORTANT!

Installing and connecting UPSs in a way that does not comply with accepted practices releases Infosec
Communication from any liability.

1-1. Transportation and Storage


Please only use the original packaging when transporting the UPS system to protect against
shock and impact.

The UPS must be stored in a room that is ventilated and dry.

1-2. Preparation


Condensation may occur if the UPS system is moved directly from a cold to warm environment.
The UPS system must be absolutely dry before being installed. Please allow at least two hours
for the UPS system to acclimatize to the environment.

Do not install the UPS system near water or in damp environments.

Do not install the UPS system where it would be exposed to direct sunlight or near a heater.
Do not block air ventilation holes in the UPS housing. The UPS must be installed in a
location with good ventilation or with air-conditioning. Ensure enough space on each
side for ventilation. Ideally, the room temperature doesn't exceed 20°C and 0-90%
non-condensing humidity.

1-3. Installation


Do not connect appliances or devices which would overload the UPS (e.g. large motor-type
equipment) to its output sockets or terminal.

Do not connect domestic appliances such as hair dryers to UPS outlets.

Place cables in such a way that no one can step on or trip over them.

The UPS provides a grounded terminal, in the final installed system configuration and
equipotential ground bonding to the external UPS battery cabinets.

The UPS may only be installed by qualified maintenance personnel.

An appropriate disconnection device for short-circuit backup protection should be provided in the
building wiring installation.

An integral single emergency switching device to prevent further supply to the load by the UPS
regardless of the mode of operation should be provided in the building wiring installation.

Connect the ground before connecting to the building wiring terminal.

Installation and wiring must be performed in accordance with local electrical laws and
regulations.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
39
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 06 14 AA 59 203 45