Wisniowski UNITHERM SSp Notice De Montage page 6

EN
[D000100] Assembly
1. The device should be assembled during the installation of the door first bot-
tom panel. Installation of the device at the later stage of the assembly is much
more complicated due to the hinges and panels.
2. The device should be fitted without a panel mounting plate. The plate should
be connected with the device before fixing it to the panel.
3. During the assembly, the roller should be connected with the device casing.
4. The device should be installed in the guide when the spring on a lever is
tightened (the lever fixing the cable should be turned downwards).
Actions to be performed when the device is activated (blocked)
• Secure the door leaf against drop-down.
• Release the spring tension.
• To easily turn the lever, firstly lift the door leaf slightly, and then pull the lever
downwards.
• Dismantle the safety device.
ATTENTION! If the device was activated (was used), it is
obligatory to replace it with a new one.
It is necessary to change all door components that have
been damaged in the result of safety device activation.
[D000105] Maintenance
Anti-drop safety device does not require special maintenance. However, it is
necessary to keep it clean and protect against dust, especially sand. In case of
any cables damages, it should be immediately replaced.
Actions to be performed during maintenance inspection
The following actions are to be performed during maintenance inspection:
1. Release the door spring tension.
2. Check the condition of the spring fixing the lever.
3. Check if the cutter lever to which the cable is screwed, operates smoothly,
without jerks.
4. Check if the top roller moves smoothly in the sleeve. If necessary, lubricate it
with consistent grease.
If any irregularities in the safety device operation are observed, IT IS PROHIBIT-
ED to do any repairs. The device should be obligatory replaced with a new one.
[A000060] Disconnect the drive power supply during all
maintenance and inspection works.
[A000011] All works must be performed according to this Assembly and Op-
erating Instruction of the door. Any comments or recommendations must be
submitted to the Owner in writing, e.g. to be noted in the door report book or
warranty card, and submitted to the door Owner. Upon performing the inspec-
tion, this fact must be confirmed by corresponding note in the door report book
or warranty card.
[A000012] "WIŚNIOWSKI" Sp. z o.o. S.K.A. reserves the right to
introduce design modifications due to technological progress that
do not alter the product functionality, without prior notice.
This documentation is copyright of "WIŚNIOWSKI" Sp. z o.o.
S.K.A. Copying, reproduction and usage in full or in a part with-
out the written consent of the owner is prohibited.
[A000048] This document has been translated from Polish. In case
of discrepancies, the Polish version prevails.
6
Assembly and Operating Instructions – Sectional garage door UniTherm
IIiO/BS/UniTherm/07/2015/ID-95145 Technical description
+