Télécharger Imprimer la page

Siemens HD2525U Instructions D'installation page 3

Publicité

Les langues disponibles

Les langues disponibles

!
Important Safety Instructions
Important Safety Instructions ................................................................................................. 1
Preparation .......................................................................................................................... 4
Installation .......................................................................................................................... 6
Final Steps .......................................................................................................................... 8
Service ................................................................................................................................ 9
PLEASE READ AND SAVE ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
PARTS PROVIDED:
Anti-Tip Bracket
TOOLS AND PARTS NEEDED:
Range Power Supply Cord Kit with strain relief
(240V - 30 Amps)*
Standard Measuring Tape
Phillips Head Screwdriver
1-1/4" Wrench
Pencil
T-20 Torx Screwdriver
3/8" Nut Driver
Screws (2) and Anchors (2) for Anti-tip Bracket
(Style will vary depending on mounting surface)
Pipe Wrench (2)
Teflon® Tape** or Pipe Joint Compound (Appropriate
for use with LP gas and Natural gas)
Channel Lock Pliers
Gas Leak Test Solution
Level
Drill and Drill Bit
Gas Supply Line (Flexible Metal Appliance Connector
or Rigid Pipe)
Gas Shut Off Valve (If not already present)
Gloves and Safety Goggles
* Not required for Canadian Installations.
** Teflon is a registered trademark of DuPont.
WARNING: If the information in this manual
is not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
Do not store or use combustible materials,
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
appliance.
− − − − −
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use any phone in your building.
Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
If you cannot reach your gas supplier,
call the fire department.
− − − − −
Installation and service must be performed
by a qualified installer, authorized service
agency or the gas supplier.
Table of Contents
Do not repair or replace any part of the appliance
unless specifically recommended in the manuals.
Improper installation, service or maintenance can
cause injury or property damage. Refer to this manual
for guidance. All other servicing should be done by a
qualified technician.
For Massachusetts Installations:
1. Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter qualified or
licensed by the state, province or region where this
appliance is being installed.
2. Shut-off valve must be a "T" handle gas cock.
3. Flexible gas connector must not be longer than 36
inches.
RANGE TIPPING HAZARD
All ranges can tip and injury could result. To
prevent accidental tipping of the range,
attach it to the wall, floor or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appliance is
not installed in accordance with these
instructions.
If the range is pulled away from the wall for
cleaning, service, or any other reason, ensure
that the Anti-Tip Device is properly
reengaged when the range is pushed back
against the wall. In the event of abnormal
usage (such as a person standing, sitting, or
leaning on an open door), failure to take this
precaution could result in tipping of the
range. Personal injury might result from
spilled hot liquids or from the range itself.
WARNING
WARNING
English •
1

Publicité

loading

Ce manuel est également adapté pour:

Hd2528u